Applied-engineering GS-RAM III Manuel d'utilisateur télécharger pdf (Page 15)

5) Set the Switches.

You must have the switches in the proper position in order for the

correct amount of memory to be used. Your board may use either

Flip Switches or Rocker Switches. Refer to the drawing below for

proper settings.

Memory | Switch 1 | Switch 2

1 Megabyte | Off | Off

2 Megabytes | On | Off

3 Megabytes | Off | On

4 Megabytes | On | On

Flip Switches

Rocker Switches

Set the Switches

6) Reinstall the card then test it using the appropriate

The memory test is included on the AW 3 Expander disk. The test

will give a graphic representation of the card and indicate which chips

are missing, bad or improperly installed.

Ch. 3 - Adding More Memory 11

+ Warning: Make sure that the end marked “FRONT” on

the card is toward the front of the computer.

1 Meg

2 Meg

3 Meg 4 Meg

1Meg 2 Meg 3 Meg 4 Meg

1 2 ... 10 11 12 13 14 15

Pas de commentaire

Applied-engineering GS-RAM III Manuel d'utilisateur Page 15