Applied-engineering Vulcan Manuel d'utilisateur télécharger pdf (Page 16)

CHAPTER Two

//e and ][ Plus Installation

Installation Procedure

You’ll need Phillips screwdriver to install the Vulcan. When

you have one, follow the instructions below.

1) Open Computer

Pull up on the two tabs at the rear of the case lifting the lid up

and towards you. (See picture following.)

Remove the //e or ][ Plus cover

2) Remove Cards

If you have card( installed into the expansion slot, you’ll need

to remove them to give yourself room to work.

Refer to your slot cards’ manuals for proper removal.

3) Remove Power Supply

i) Unplug external cord from bock of computer.

This is the cord that runs from the back of the computer to the

wall socket. Unplug it from the back of the computer and from

the wall socket as well.

ii) Unplug internal cord from motherboard.

The intemal power cord is the multi-wire cord running from

the power supply toward the back of the motherboard.

Ch. 2 - //e and ][ Plus Installation 9

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 61 62

Pas de commentaire

Applied-engineering Vulcan Manuel d'utilisateur Page 16