Applied-engineering Vulcan Manuel d'utilisateur télécharger pdf (Page 17)

Squeeze the left and right side of the plug to release, then pull

up.

Unplug Internal Cord

iii) Remove screws.

Turn the computer on its left side. On the bottom of the

computer you will find four screws in a rectangular pattern the

size of the power supply. While firmly holding onto the power

supply, remove the four screws. When all four are removed, lift

the power supply out of the case.

4) Remove Vulcan from Packing.

5) Check Voltage Setting

The switch setting on back of the Vulcan must be set to the

proper voltage (115 in the United States).

6) ][ Plus Users Only -- Attach Riser Plates

The two metal plates (included) must be attached to raise the

Vulcan over the ] [ Plus motherboard. Use four of the included

Phillips screws to attach the plates.

* Note: Attach the plate so that the screws are to the side

of the female stand-offs toward the long straight edge of

the Vulcan (see picture following).

10 Vulcan

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 61 62

Pas de commentaire

Applied-engineering Vulcan Manuel d'utilisateur Page 17